The waste aluminum Crushing and Recycling Line is widely used in shredding scrap aluminum alloy, scrap engine, scrap radiator, broken bridge aluminum, water tank, copper wire,and other scrap metal materials.
We can customize waste aluminum crushing and recycling production line for you.
The waste Aluminum Crusher is mainly used for crushing scrap copper and aluminum, increasing its bulk density for transportation and recycling.
This equipment is widely used in shredding scrap aluminum alloy, scrap radiator, broken bridge aluminum, scrap engine, water tank, copper wire,and other scrap metal materials.
The output particles after shredding scrap metal can be customized.
Scrap Steel Crushing Recycling Line
Waste Aluminum Crushing Production Line
Water Radiator Crushing Sorting Line
The material is sent to the double-shaft crusher through the conveyor for primary crushing. The double-shaft crusher squeezes and tears the material into small pieces, and then sends it to the vertical crusher through the conveyor for secondary crushing. , the hammer crusher fully dissociates the material fragments, squeezes and kneads them into high-density pellets, and the broken small particles are separated from the iron in the material by a magnetic separator, and the remaining copper and aluminum enter the specific gravity Sorting machine, for fine sorting, sorting out the remaining copper, aluminum and other impurities.
1. This production line has been researched by our company for many years, combined with the actual situation of the country, the processing process has lower metal loss compared with similar production line technology at home and abroad, reduces the number of broken times, and ensures that materials are separated in the maximum state, thereby reducing metal loss. The production of powder improves the efficiency of recycling.
2. The primary crushing adopts a double-shaft crusher, which adopts a two-shaft double-roller design, which has low noise, high torque, and can crush large-volume radiators.
3. The vertical crusher has strong crushing capacity. It can easily crush the materials in the water tank by one-time crushing. It does not need to remove iron in advance. The hammer head is made of alloy material, and the service life is more than one year.
4. High degree of automation, only 2-3 staff are needed on the whole line.
5. The dust collection system is equipped in the treatment process, which effectively controls the dust overflow.
6. The sorting adopts two-stage specific gravity sorting to improve the sorting accuracy, and the purity of the sorted copper, iron and aluminum is >99%.
If you need our products please write down any questions, we will reply as soon as possible.
